Initial Steps for Variant 2 (elmeg hybird 120j)

You will see whether the ISDN point-to-multipoint connection is connected correctly or not on the system's status page. The link status from the bri-1 interface is then displayed with a green arrow.

  1. Go to System Management -> Status.

System Management -> Status

The following options must then be set in the Initial Steps Wizard:

  1. Go to Assistants -> First steps -> Basic Setup.

Assistants -> First steps -> Basic Setup

Assistants -> First steps -> Basic Setup-> Advanced Settings

Proceed as follows:

  1. Enter the IP address of the bintec RS232bw™ gateway for Standard Gateway IP Address ; here it is 192.168.0.254 , for example.

  2. Enable the option Fixed DNS Server Address.

  3. Enter the IP address of the Windows Server for DNS Server 1; here it is 192.168.0.200 , for example.

  4. Enter the IP address of the bintec RS232bw™ gateway for DNS Server 2; here it is 192.168.0.254 , for example.

  5. The Use this device as a DHCP server option must be disabled as there is already a DHCP server available within the network.

  6. Enable the Update system time from time server option. If this option is not enabled, then the system time of the telephone is updated via the ISDN point-to-multipoint connection after the first outgoing call.

  7. Enter the domain name of the server for Primary NTP Time Server, e.g. pool.ntp.org .

  8. Enable System as time server. This then ensures the time is updated on elmeg IP telephones.

  9. Press OK to confirm your entries.

Go to Configuration of external ISDN port (Variants 1-3) to configure the external ISDN port to operate on the ISDN point-to-multipoint connection.

Go to Connecting an  elmeg S560™telephone (Variants 1-3) to connect an elmeg S560™ telephone, and see Connecting an elmeg IP120™telephone (Variants 1-3) to connect an elmeg IP120™ telephone.

Copyright© Version 01/2020 bintec elmeg GmbH