Connecting an elmeg S560telephone (Variants 1-3)

For the elmeg hybird 120j™, four users for system telephones (internal numbers 30, 31, 32 and 33) are already created in the ex works state. In our example, the number 30 is used for an elmeg S560™ and the number 31 is used for an elmeg IP120™.

Connect the elmeg S560™ telephone to the first ISDN port of the elmeg hybird 120j™. Connected system telephones are automatically detected and listed by the elmeg hybird 120j™.

	Note
	Please note that the elmeg S560™ system telephone is set to operating mode `S0->Line In` . The socket required for this purpose can be found on the underside of the telephone.

Go to Terminals -> elmeg System Phones -> System Phone.

Go to Terminals -> elmeg System Phones -> System Phone ->General.

Terminals -> elmeg System Phones -> System Phone ->General

For a better overview, enter a Description for the telephone, e.g. Telephone 1 .

Select the Internal Number for the terminal, e.g. 30 (#30) .

	Note
	For elmeg S560™ / elmeg S530™ system telephones, up to 5 internal numbers can be configured.

Press Apply to confirm your entries.

The settings are transferred to the elmeg S560™ telephone. By doing this, the telephone is then ready for outgoing phone calls.

The user of your system is configured in the next step. To do this, go to the following menu:

Go to Numbering -> User Settings -> <User 30> -> Basic Settings.

Numbering -> User Settings -> <User 30> -> Basic Settings

For a better overview, the Name of the user can be assigned, e.g. Bloggs-30 .
Leave the remaining settings unchanged and confirm them with Apply.

In the Numbers submenu, the subscriber with the internal number 30 can be assigned a name for a better overview.

Go to Numbering -> User Settings -> <User 30> -> Numbers.

Enter the name of the user under Displayed Description, e.g. Bloggs-30 .
Check the System Phonebook option. The configured name and the corresponding internal number are then transferred to the system telephone book.
Press Apply to confirm your entries.

Now the Outgoing Signalisation submenu specifies which external number is to be signalled for this user on outgoing calls. Here, select one of the multiple subscriber numbers (MSNs) that have been configured.

	Note
	If no external number is defined for the internal number, then any outgoing external calls are signalled with the first number of the point-to-multipoint connection.

Go to Numbering -> User Settings -> <User 30> -> Outgoing Signalisation <30> .

Numbering -> User Settings -> <User 30> -> Outgoing Signalisation <30>

Under ISDN External, select one of the multiple subscriber numbers (MSN) already configured, e. g. 587564 .
Confirm with Apply.

In the next configuration step, you define the incoming distribution, i.e. specify with which external number the user Bloggs-30 can be reached.

Go to Numbering -> Call Distribution -> Incoming Distribution .

Under Assignment, select Internal Number .
For Internal Number, select 30 (Bloggs-30) .
Confirm with OK.