| Slot |
| Identification number of the used slot. Range: 0 to 31 |
| Unit |
| Identification number of the used unit. Range: 0 to 31 |
| Type |
| The type of the connected device on socket a. Possible values are: - any(1), (multifunctional) - fax(2), - telephony(3), - modem(4), - disable(5), - doorintercom(6), - answering(7), (-machine) - emergency(8) (-telephone) - alarmInput(9) (sensor function) Enumerations: - any (1)
- fax (2)
- telephony (3)
- modem (4)
- disable (5)
- doorintercom (6)
- answering (7)
- emergency (8)
- alarmInput (9)
|
| IfMode |
| Type of outlet. Enumerations: |
| IfAdminState |
| This variable allows for taking an POTS interface out of/in service w/o having to touch the configuration. Besides, it is possible to initiate a reconfiguration for that interface in case a mismatch in configuration parameters (hardware vs. software) was detected. Inconsistencies with the need of reconfiguration is a differing potsIfMode (fxo/fxs). In case of mismatch, contents of this variable might be wrong and this circumstance is reflected in variable potsIfOperState. State reconfig may then be used in order to cause an update of these variable as appropriate which ... - will be signalled to higher protocol layers, and - can result in extensive reconfiguration steps The latter may also cover clean-ups undoable by system so this decision is left to the user. Default value is down. Enumerations: - down (1)
- up (2)
- reconfig (3)
|
| IfOperState |
| The operational state of an interface is indicated via this variable. Possible values are: - down(1), - running(2), - fail(3), - not-connected(4), - stopped(5), - stopping(6), - starting(7), The latter two states being of transitional type, mainly for hot-plug type hardware, and won't be normally seen by user. State fail is used to reflect inconsistencies between hardware state and configuration concerning interface mode (potsIfMode). Enumerations: - down (1)
- running (2)
- fail (3)
- not-connected (4)
- stopped (5)
- stopping (6)
- starting (7)
|
| IfIndex |
| Reference to the FXS or FXO table. |
| IfTtxLevel |
| Teletax (metering pulse) level: for FXS lines: output level for FXO lines: minimum level Range: -50 to 0 |
| IfTtxFreq |
| Teletax (metering pulse) frequency: 1: no teletax output/reception 3: 12 kHz 4: 16 kHz Enumerations: - off (1)
- freq12khz (3)
- freq16khz (4)
|
| IfCoeffIndex |
| Selection of the coefficient set provided by the FXS or FXO line driver. This allows to use specific settings with e.g. resistive or complex line impedances. Supported values are: 600: 600 ohms (resistive) 1155: german Zr (complex) 1170: ETSI (complex) |
| IfTxGain |
| Amplification or attenuation (negative gain) of outgoing audio in dB. Range: -30 to 10 |
| IfRxGain |
| Amplification or attenuation (negative gain) of incoming audio in dB. Range: -30 to 10 |
| IfDialInTimeout |
| Limit for time interval between two consecutive dialling digits. Range: 1 to 99 |