| IfIndex |
| Index of the FXS interface. |
| FlashMinTime |
| Minimum flash duration (ms). Flash pulses below this value will be ignored. |
| FlashMaxTime |
| Maximum flash duration (ms). Flash pulses above this value will be interpreted as hook-on. |
| RingLevel |
| Peak value of sinusoidal ringing voltage. Range: 0 to 150 |
| RingFreq |
| Frequency of sinusoidal ringing voltage. Enumerations: |
| RingTableIndex |
| The ringing table index is the reference to all ringing cadences used for this extension. Definitions are in phoneIfRingTable. |
| ToneTableIndex |
| The tone table index refers to the tones used for this extension. Definitions are in phoneIfToneTable |
| DataLinkType |
| Allowed data transmission message types: setup - call setup message mwi - message waiting indicator message aoc - advice of charge message sms - short message service message Enumerations: - setup (0)
- mwi (1)
- aoc (2)
- sms (3)
|
| DataLinkElem |
| Allowed data transmission parameters (see ETSI EN 300 659-3). Not selected elements will be filtered out and not sent to the subscriber. Enumerations: - date-time (0)
- calling-line-id (1)
- called-line-id (2)
- reason-for-absence-of-cli (3)
- calling-party-name (4)
- reason-for-absence-of-cpn (5)
- visual-indicator (6)
- message-identification (7)
- last-message-cli (8)
- complementary-date-time (9)
- complementary-cli (10)
- call-type (11)
- first-cli (12)
- no-of-messages (13)
- charge (14)
- additional-charge (15)
- duration-of-call (16)
- network-provider-id (17)
- carrier-id (18)
- select-terminal-function (19)
- display-information (20)
- service-information (21)
|
| DataLinkLevel |
| Level of the data transmission signal (dB). Range: -30 to 0 |
| DataLinkTiming |
| Index of the timer set to be used for on-hook and off-hook data transmission. |
| DataLinkModeOnHook |
| Selection of on-hook data transmission mode: 1: no on-hook data transmission 2: data transmission prior to ringing with DT-AS 3: data transmission prior to ringing with DT-AS and polarity reversal 4: data transmission prior to ringing with RP-AS 5: data transmission during ringing (after first ring) 6: data transmission using DTMF Enumerations: - off (1)
- dt-as (2)
- dt-as-pol-rev (3)
- rp-as (4)
- during-ringing (5)
- dtmf (6)
|
| DataLinkModeOffHook |
| Selection of off-hook data transmission mode: 1: no off-hook data transmission 2: data transmission prior using DT-AS Enumerations: |
| DialPulseMinTimePulse |
| Pulse dialling break time minimum (ms). Break pulses below this limit will be ignored. Range: 10 to 100 |
| DialPulseMaxTimePulse |
| Pulse dialling break time maximum (ms). A pause time above this limit is regarded as on-hook signal. Range: 50 to 200 |
| DialPulseMinTimePause |
| Pulse dialling make time minimum (ms). Make pulses below this limit will be ignored. Range: 10 to 100 |
| DialPulseMaxTimePause |
| Pulse dialling make time maximum (ms). A pause time above this limit finishes the pulse counting and this digit is regarded as complete. Range: 10 to 300 |