>> MIB - Management Information Base

>> Table: ip6DynRouteTable - (.1.3.6.1.4.1.272.4.5.100.2.9.1)

Description: A dynamically created routing entry.

ip6DynRouteTable
OIDNameTypeAccess
.1CreatorENUMR
.2TargetInetAddressIPv6R
.3TargetLenINTEGERR
.4SourceInetAddressIPv6R
.5SourceLenINTEGERR
.6IfIndexInterfaceIndexR
.7NextHopInetAddressIPv6R
.8PriorityINTEGERR

Creator
The creator of the dynamic routing-entry, can be DHCPv6 or any other (routing-)protocol.

Enumerations:

  • netmgmt (2)
  • rip (4)
  • ospf (5)
  • bgp (6)
  • idrp (7)
  • dhcp-pd (8)
Target
The destination IPv6 address of this route. This object may not take a multicast address value.

Length: 16 to 16

TargetLen
Indicates the prefix length of the destination address.

Range: 0 to 128

Source
The Source IPv6 address of this route. This object may not take a multicast address value.

Length: 16 to 16

SourceLen
Indicates the prefix length of the source address.

Range: 0 to 128

IfIndex
The index value which uniquely identifies the local interface through which the next hop of this route should be reached. The interface identified by a particular value of this index is the same interface as identified by the same value of ip6DeviceIfIndex. For routes of the discard type this value can be zero.

Range: 1 to 2147483647

NextHop
On remote routes, the address of the next hop of this routing entry, set to :: otherwise.

Length: 16 to 16

Priority
The routing priority for this route, a value of 0 means highest priority, a value of 16 lowest priority.

Range: 0 to 16


MIB Reference to Software Version 10.2.12 generated on 2023/08/29. Provided by webmaster@bintec-elmeg.com
Copyright ©2023 by bintec elmeg GmbH