| Slot |
| The slot, or location of this module. Range: 0 to 31 |
| Type |
| The name of this module. Length: 0 to 255 |
| HWRelease |
| The hardware release of this module. Length: 0 to 255 |
| FWRelease |
| The firmware release of this module. Length: 0 to 255 |
| PartNo |
| The part number of this module. Length: 0 to 255 |
| Connector |
| The type of connector used for this module. For modules with more than one connector this value can be changed/switched by setting this object. For example, the CM-BNCTP module supports both twisted pair (RJ45) and 10Base2 (BNC) connectors. If this object is set to 'AUTO' then the BRICK will automatically detect which connector type is being used. Enumerations: - auto (1)
- rj45 (2)
- bnc (3)
- subd15 (4)
- rj45-10mbit-hdup (5)
- rj45-10mbit-fdup (6)
- rj45-100mbit-hdup (7)
- rj45-100mbit-fdup (8)
|
| Unit |
| The logical unit number of this interface. Range: 0 to 99 |
| SerialNo |
| The serial number of this module. Length: 0 to 255 |
| Category |
| Board category. It can be one of the following: system-board(1), ethernet(2), isdn-bri(3), isdn-pmx(4), pots(5), dsl(6), wlan(7), tty(8), dsp(9), usb(10), crypt(11), mobile(12) It advices users of which MIB table to look at when searching for additional configuration informations. Enumerations: - system-board (1)
- ethernet (2)
- isdn-bri (3)
- isdn-pmx (4)
- pots (5)
- dsl (6)
- wlan (7)
- tty (8)
- dsp (9)
- usb (10)
- crypt (11)
- mobile (12)
|