Set up the default route |
The default route via interface en1-0 to the VPN concentrator's IP address is then set up on the WLAN controller.
Go to Network -> Routes -> IPv4 Route Configuration -> New.
Network -> Routes -> IPv4 Route Configuration -> New
Proceed as follows:
Set the Route Type to Default Route via Interface .
As the Interface, select LAN_EN1-0 .
Under Local IP Address, select the IP address of the host to which your device will pass the IP packets, in this case the VPN concentrator's LAN ID address 10.0.0.1 .
Set the Metric of the route to e. g. 1 to select the route's priority. The lower the value, the higher the priority of the route.
Select OK to confirm your entries.
The IP routes overview then looks like this:
Network -> Routes -> IPv4 Route Configuration
This completes the configuration of the VPN concentrator. Save the configuration with Save configuration and confirm the selection with OK.
Copyright© Version 01/2020 bintec elmeg GmbH |