Introduction |
The following section describes how to configure a WLAN access to the local network and a guest WLAN. To integrate additional Access Points, use the Wireless LAN Controller. For the separation of both networks on Layer 2 level, a VLAN is configured for the guest network. The users of the guest WLAN have unrestricted access to the internet, but no access to the local network.
Note | |
---|---|
The Trunk Link (see illustration) leads to RS353aw™ with one of the four ETH Ports (ETH1 to ETH4), which are assigned 1-0 by default. |
The following prerequisites for configuration must be met:
An RS-series device, a be.IP or be.IP plus
A boot image of version 10.1.9 patch 3 or above
Switches, which support 802.1q VLAN
The GUI™ (Graphical User Interface) is used for configuring.
Copyright© Version 01/2020 bintec elmeg GmbH |