Configuration on bintec S128p

The switch must be configured in the same way as the access point. Only tagged (VLAN) packets must be processed in the access point direction. Tagging must be removed in the client direction, otherwise the clients cannot process the packets.

  1. Launch the browser and log in to the switch.

  2. Go to Protocol -> VLAN.

  3. Under VLAN Operation Mode select 802.1Q .

  4. Click Apply.

Protocol -> VLAN -> VLAN Configuration

A total of 3 VLANs are required. In each case the Port (Port.01, Port.02, Port.03) and Untagged Vid (1, 102, 103) must be set correctly.

Proceed as follows to configure the ports:

  1. Under Port select Port.01 .

  2. Set Link Type to Access Link .

  3. Under Untagged Vid enter 1 .

  4. Press Apply to confirm your entries.

  5. Proceed in the same was to configure Port.02 (Untagged Vid 102 ) and Port.03 (Untagged Vid 103 ).

  6. Press Apply to confirm your entries.

  7. Under Port select Port.08 .

  8. Set Link Type to Trunk Link .

  9. Under Tagged Vid enter 1,102,103 .

  10. Press Apply to confirm your entries.

The complete configuration looks like this:

Protocol -> VLAN -> VLAN Configuration

Checking the connection

To check the configuration, call up the command prompt on a PC and send a ping to the head office network:

e.g. ping 192.168.100.30

You should then receive the following message:

Copyright© Version 01/2020 bintec elmeg GmbH