Configuring the wireless networks

You must set up wireless networks on the access points so that the clients can connect to the network over their access point.

Proceed as follows to create wireless networks:

  1. Go to Wireless LAN -> WLAN-> Radio Settings.

Configure the wireless module by editing the default entry. To do this, click the icon next to the existing entry.

Wireless LAN -> WLAN-> Radio Settings ->

Proceed as follows:

  1. Set Operation Mode to Access-Point /Bridge Link Master .

  2. Set the Channel to 11 for example.

  3. Confirm with OK.

Then create the wireless network entries.

  1. Go to Wireless LAN -> WLAN->Wireless Networks (VSS)->.

Configure the WLAN connection by editing the default entry.

Wireless LAN -> WLAN1->Wireless Networks (VSS)->

Proceed as follows:

  1. Under Network Name (SSID) enter Management for example.

  2. Under Network Name (SSID) the Visible option remains enabled.

  3. Set the Security Mode to WPA-PSK .

  4. Under Preshared Key enter Key-Admin , for example.

  5. Confirm with OK.

Note

You should use special characters, numbers and upper and lower case letters in your key to increase security.

You must then enable the wireless network you have just configured. To do this, go to the overview in the Wireless LAN -> WLAN->Wireless Networks (VSS).

Wireless LAN -> WLAN->Wireless Networks (VSS)

Proceed as follows:

  1. In the currently only list entry click the icon in the Action column. Refer to the Status column: After a short delay, the icon will be displayed here.

Configure the corresponding new entries for the wireless networks Development and Public .

Note

Make sure that you assign different Preshared Keys to the various wireless networks.

Next configure the wireless adapter of the clients in your network to connect to their corresponding wireless network (VSS).

Copyright© Version 01/2020 bintec elmeg GmbH