NAT entries for administration with the GUI

You should be able to administrate your gateway using HTTP over the Internet. Go to the following menu to configure the corresponding NAT enable:

  1. Go to Networking -> NAT -> NAT Configuration -> New.

Networking -> NAT -> NAT Configuration -> New

Relevant fields in the Portforwarding menu

Field Meaning
Interface This is the connection that the NAT enable should receive.
Service This is the service you reach from outside the gateway.
Source IP Address/Netmask Enter the external IP address of the gateway here.
New Destination Port The IP address to which you wish to be forwarded when you reach the gateway.

Proceed as follows to configure the NAT enable:

  1. Set the Interface to WAN_INTERNET for example.

  2. Configure the Service to http .

  3. Under Source IP Address/Netmask select Any .

  4. Leave other settings unchanged and confirm your entries with OK.

Copyright© Version 01/2020 bintec elmeg GmbH