Configuring Internet access |
The Internet connection can be set up in a few steps via the Assistant. For this, go to the following menu:
Go to Assistants -> Internet Access-> Internet Connections -> New.
For Connection Type, select External xDSL Modem .
Click on Next to configure a new Internet connection.
Enter the access data required for the connection.
Assistants -> Internet Access -> Internet Connections -> New -> Next
Proceed as follows to set up the Internet connection:
Under Description enter e.g. Telekom - VDSL .
For Physical Ethernet Port, select the network port with which the VDSL modem has been connected to the elmeg hybird 120/130™. In our example, the port used is the ETH4 Ethernet port, which is located next to the ADSL port. This setting reduces the 4 port switch on the elmeg hybird 120/130™ by one port, which separates the LAN and WAN connection.
As the Country, select Germany .
For Internet Service Provider, select Telekom - VDSL .
Under Connection ID, enter the 12 digit number taken from Telekom's order confirmation, e. g. 000123456789 .
Under T-Online Number, enter the 12 digit number taken from Telekom's order confirmation, e. g. 112233445566 .
Enter the 4 digit Co-User Number, e. g. 0001 .
For Password, enter the personal ID taken from Telekom's order confirmation, e. g. supersecret .
Enable the Always active option.
Press OK to confirm your entries.
The WAN connection status can then be controlled on the system's status page.
System Management -> Status
Copyright© Version 01/2020 bintec elmeg GmbH |