Introduction

The following describes how to set up a SIP provider in the elmeg hybird™.

	Note
	The pictured information is only provided as an example. Please use the data obtained from your SIP provider. Certain presettings are of importance when using a domestic SIP provider in order, for example, to ensure that only the number is entered, as opposed to the entire area code and number, when making a local call.

Variant 1

In this example, the elmeg hybird 120™ or elmeg hybird 130™ are connected directly to the Internet via your internal DSL modem.

Example scenario

Requirements

Internet access via the integrated ADSL/ADSL2+ modem
An elmeg hybird 120™ as of system software version 9.1, Rev. 2, is used as a DHCP and DNS server in the network.
elmeg IP120™ telephone as of firmware version 01.00.04
elmeg S560™ telephone as of firmware version 1.400
Connecting the elmeg hybird™ to all terminals and connections as indicated in the circuit diagram

Variant 2

This example describes how to integrate an elmeg hybird 120™, elmeg hybird 130™, elmeg hybird 300™ or elmeg hybird 600™ into an existing network with a gateway, e.g. bintec RS232bw™.

Example scenario

Requirements

An existing network with bintec RS232bw™ gateway, as of system software version 9.1, Rev. 2. The bintec RS232bw™ gateway is used as a DHCP and DNS server in the network.
An elmeg hybird 600™ as of system software version 9.1, Rev. 2
elmeg IP120™ telephone as of firmware version 01.00.04
elmeg S560™ telephone as of firmware version 1.400
Connecting the elmeg hybird™ to all terminals and connections as indicated in the circuit diagram