Initial Steps for Variant 3 (elmeg hybird 120j)

If the ASDL interface and the ISDN point-to-multipoint connection are correctly connected, then the link status of both interfaces is displayed with green arrows on the system status page.

  1. Go to System Management -> Status.

System Management -> Status

The following options must then be set in the Wizard:

  1. Go to Assistants -> First steps -> Basic Setup.

Assistants -> First steps -> Basic Setup

Assistants -> First steps -> Basic Setup-> Advanced Settings

Proceed as follows:

  1. Enable the Use this device as a DHCP server option.

  2. Enable the elmeg VoIP Provisioning Server option. The DHCP option 114 (URL) is then assigned to the IP address pool required for the provisioning of elmeg IP telephones.

  3. Under IP Address Range, enter 192.168.0.10 - 192.168.0.30 , for example. The IP address range can be adjusted where necessary.

  4. Enable the Update system time from time server option. If this option is not enabled, then the system time of the telephone is updated via the ISDN point-to-multipoint connection after the first outgoing call.

  5. Enter the domain name of the server for Primary NTP Time Server, e.g. pool.ntp.org .

  6. Enable System as time server. This then ensures the time is updated on elmeg IP telephones.

  7. Press OK to confirm your entries.

Copyright© Version 01/2020 bintec elmeg GmbH