Configure tunnel with the Assistant VPN

In order to configure the tunnel, use Assistants VPN.

  1. Go to Assistants->VPN->VPN Connections->New.

  2. Select VPN Scenario IPSec - Single Client Dialin .

    Assistants->VPN->VPN Connections->New

  3. Click Next to confirm your selection.

Enter the required data for the IPSec scenario in the next step.

Assistants->VPN->VPN Connections->New->Next

Proceed as follows:

  1. Under Description enter a name for the connection, e. g. IPSec_Connection_1 .

  2. Leave the Local IPSec ID unchanged.

  3. At Remote IPSec ID enter the ID of the remote IPSec peer, e.g. IPSec_Connection_1 .

  4. A Preshared Key is used for authentication.

    Note

    As Preshared Key we recommend using a combination of letters, numbers, and symbols.

  5. Under Select IP Address Pool select a suitable IP address range such as DHCP address range or configure a new address range under WAN->Internet + Dialup->IP Pools->New. In order to configure a new address range, use View Full Access .

    Note

    We recommend using an IP pool with addresses from the gateway's internal network.

  6. Activate Export configuration file for bintec Secure IPSec Client.

    Note

    The exported *.ini file can be imported into a be.IP Secure Client as well as into a bintec elmeg IPSec Secure Client.

  7. Click OK to confirm your entries.

    The following window opens:

    Assistants->VPN->VPN Connections->New->Next->OK

  8. Click Export.

    An addition window opens.

  9. Select Save File then click OK.

    The ini file is saved.

Copyright© Version 01/2020 bintec elmeg GmbH