Using further functions of the be.IP |
You can use further functions of the be.IP™.
To do this on the be.IP™ you must
change your IP address
deactivate the DHCP server
set up the die standard route to be.IP plus™
enter be.IP plus™ as the DNS server.
Go to Wizards -> Initial Steps -> Basic Settings.
Change your IP Address, e.g. into 192.168.2.2 .
Deactivate Use this device as DHCPv4 server.
Under Default Gateway IP Address, enter e.g. 192.168.2.1 to make the standard route show on the device with the PPPoE WAN partners.
Under DNS-Server 1, enter the same IP address as above to add this device as a DNS server, e.g. 192.168.2.1 .
After plugging in, br0 , for example, is available as a switch extension. You can also access the network from other functions like Access Point or IPSec.
Copyright© Version 01/2020 bintec elmeg GmbH |