Introduction |
The following section describes how to configure a WLAN access to the local network and a guest WLAN. To integrate additional Access Points, use the Wireless LAN Controller. For the separation of both networks on Layer 2 level, a VLAN is configured for the guest network. The users of the guest WLAN have unrestricted access to the internet, but no access to the local network.
Example WLAN scenario with guest WLAN
![]() |
Note |
---|---|
The Trunk Link (see illustration) leads to RS353aw™ with one of the four ETH Ports (ETH1 to ETH4), which are assigned 1-0 by default. |
The following prerequisites for configuration must be met:
An RS-series device, a be.IP or be.IP plus
A boot image of version 10.1.9 patch 3 or above
Switches, which support 802.1q VLAN
The GUI™ (Graphical User Interface) is used for configuring.
Copyright© Version 08/2020 bintec elmeg GmbH |