Creating an IPSec peer |
The IPSec Peers submenu offers you the New option for adding connection partners for IPSec.
Go to VPN -> IPSec -> IPSec Peers-> New.
Proceed as follows to make the settings in the IPSec peer:
Enter a Description for the connection, e.g. Branch Office .
Enter the gateway IP address or DynDNS name of the connection partner, e.g. branchoffice.dyndns.org under Peer Address.
Under Peer ID leave Fully Qualified Domain Name (FQDN) and enter Branch Office .
Enter bintec as the shared password for the connection in Preshared Key.
Deselect the Default Route option.
Under Local IP Address enter 192.168.0.10 .
Under Route Entries click Add to add a new entry.
Under Remote IP Address enter the partner network to be reached, e.g. 192.168.1.0 and under Netmask enter 255.255.255.0
Press OK to confirm your entries.
Note | |
---|---|
As you will use the certificates for your connection later, the complexity of the preshared keys is not important for this temporary connection. |
Creating an IPSec peer automatically generates standard profiles for phase 1 and phase 2, which are changed in the following section to suit the requirements of this scenario.
Copyright© Version 08/2020 bintec elmeg GmbH |