Variants 1 + 2: Configuration of country settings in the  be.IP plus

By setting the parameters International Prefix / Country Code/Country Code and National Prefix / City Code/Area Code, international and national numbers are automatically generated without the need for any additional entries when dialling them via the SIP provider. Such configuration also allows the correct distribution of calls for incoming call via the SIP provider.

  1. Go to System Management->Global Settings->System.

System Management->Global Settings->System

Proceed as follows to configure the codes:

  1. Enter the country code under International Prefix / Country Code, e.g. 49 for Germany. If this is not entered, then the full number along with the country code must always be dialled when using SIP providers.

  2. Enter the area code for the location where your system is installed under National Prefix / City Code, e.g. 911 for Nuremberg. If this is not entered, then the number along with the national prefix/area code must be dialled for local calls when using SIP providers.

  3. Leave the remaining settings unchanged and confirm them with OK.

Copyright© Version 08/2020 bintec elmeg GmbH