Introduction |
The following describes how to set up a SIP provider in the be.IP plus™.
![]() |
Note |
---|---|
The pictured information is only provided as an example. Please use the data obtained from your SIP provider. An overview of the SIP providers tested so far can be found on the internet at http://faq.bintec-elmeg.com/index.php/Konfiguration_SIP_Provider. Certain presettings are of importance when using a domestic SIP provider in order, for example, to ensure that only the number is entered, as opposed to the entire area code and number, when making a local call. |
In this example, the be.IP plus™ are connected directly to the Internet via your internal DSL modem.
Example scenario
Internet access via the integrated ADSL/ADSL2+ modem
An be.IP plus™ as of system software version 10.1, Rev. 5, is used as a DHCP and DNS server in the network.
elmeg IP120™ telephone as of firmware version 01.00.04
elmeg S560™ telephone as of firmware version 1.400
Connecting the be.IP plus™ to all terminals and connections as indicated in the circuit diagram
This example describes how to integrate an be.IP plus™ into an existing network with a gateway, e.g. bintec RS353jw™.
Example scenario
An existing network with bintec RS353jw™ gateway, as of system software version 10.1, Rev. 4. The bintec RS353jw™ gateway is used as a DHCP and DNS server in the network.
An be.IP plus™ as of system software version 10.1, Rev. 5
elmeg IP120™ telephone as of firmware version 01.00.04
elmeg S560™ telephone as of firmware version 1.400
Connecting the be.IP plus™ to all terminals and connections as indicated in the circuit diagram
Copyright© Version 08/2020 bintec elmeg GmbH |