Readme for system software 7.1.12 PATCH 2
=========================================
=========================================

The following changes have been made to our software since the release of system software 7.1.12 Patch 1. They have been included in system software 7.1.12 PATCH 2 which is available from the Funkwerk Entwerprise Communications web server for all X-Generation and VPN Access Products.


1. IP Accounting - Panic after Activation
   (ID 3821 / VPN Access and X-Generation Gateways / 7.1.12)
===========================================================
After activating IP Accounting, the gateway panics and reboots.

The problem has been solved.


2. Setup Tool - False MAC Address Displayed
   (ID 3846 / VPN Access and X-Generation Gateways / 7.1.12)
============================================================
After specifying a MAC address for any of the Ethernet interfaces, the menus for the configuration of the remaining interfaces will show the same MAC Address.
This is a display Problem only. 

The problem has been solved.


3. Bridging - Packet Loss or Corruption
   (ID 3875 / VPN Access Gateways/ no info)
===================================================
After activating Bridging, data transfer on the Ethernet interfaces can be lossy or corrupted.

The problem has been solved


4. Setup Tool - Display Reset in Monitoring Menu
   (ID 2633 / all X2000 Gateways / 6.3.1)
================================================
The values displayed in [Monitoring and Debugging > xDSL Credits > PPPoE Credits] are reset to "0" two seconds after you enter the menu.

The problem has been solved.


5. Setup Tool - Load Balancing Configuration Incorrectly Written to MIB
   (ID 3680 / all products / 7.1.6)
=======================================================================
When configuring IP Load Balancing over Multiple Interfaces with Distribution Policy = "service/source-based routing", wrong entries are written to the ipExtRtTable. This may lead to a malfunction of the Load Balancing.

The Problem has been solved.


6. Bridging - Memory Leak
   (all products / 7.1.6)
===========================================
A memory leak occours if the spanning tree message is not forwarded because the message is to old.

The problem has been solved.
 

7. Setup Tool - Exit after Entering Monitoring Menu
   (ID 3882 / all X2000 Gateways / 6.3.1)
===================================================
Entering the Monitoring Menu closes the Setup Tool.

The problem has been solved.


8. Setup Tool - Routing Entries Corrupted
   (ID 3576 / all products / 7.1.1)
=========================================
When a WAN partner route with transit network is edited in [IP > Routing > ADD/EDIT] the route type is nevertheless displayed as "route without transit network". When confirming with SAVE, the transit network configuration is lost.

The problem has been solved.


9. Syslog  - "Dump" Causes Stack Trace
   (ID 3648 / all products / 7.1.x)
======================================
Choosing "dump" for [Security > Access Lists > Interfaces > EDIT]: Reporting Method causes a stack trace when packets are actually discarded and the packet content is dumped to the syslog message.

The problem has been solved.


10. FAX  - Hardware Fax not Working
   (X4x00, X8500 / 7.1.x)
======================================
Hardware Fax is not working.

The problem has been solved.


11. PPPoE  - Negotiation Timeout to short.
   (ID 3756 / all products / no info)
===========================================
The PPPoE negotiation timeout (2s) was to short for some special scenarios. 

The negotiation timeout has been increased to 4 seconds.